schließen
Great Britain 
EN

Main units

Trimming unit

The trimming units on the reference and operator side are equipped with 22 kW motors. The cylindrical mills ø 400 x 100 mm equipped with exchangeable inserts have a speed of 3000 rpm. The operator-side unit adjusts itself to the desired panel width and has a mechanical width control. 

The maximum chip removal during one milling pass is up to 25mm.

 

Vertical end milling units

The motors, which drive the up to 2 vertical milling units, achieve power of 43 kW and a speed of 12,000 rpm. Any milling cutter up to a diameter of 80 mm and a cutting edge length of 320 mm can be clamped on the manual HSK 80 holder. For milling cutters with a smaller diameter, an HSK adapter for receiving a collet chuck is available.

In this way, panels can be formatted on the end face and any rebates, grooves or openings can be produced on the underside of the panel. With motor speed regulation, the optimal cutting speed can be also set for each tool.